'Candle Ice Two' (Phase 1) by Shane Wilson
February 15, 2012 Categories: Candle Ice Two
The antlers have been 'skinned' and prepared to receive the design, which will be created directly on the surface of the antlers. Skinning the antlers is effected by lightly sanding the surface with an angle grinder and sanding disks.
I have used a variety of angle grinders over the years and have found the Walter 4.5" slip-clutch grinder to be a superior tool. It operates very smoothly, with no wrenching action on start-up, and disk changes are a breeze.
I have used a variety of angle grinders over the years and have found the Walter 4.5" slip-clutch grinder to be a superior tool. It operates very smoothly, with no wrenching action on start-up, and disk changes are a breeze.