'Skullpture Series' (Large Mold - Phase 12) by Shane Wilson
July 03, 2003 Categories: Skullpture Series
Repeat of step 11. Note that there were two high points on this side. Two holes were drilled. When the lower high point filled, it was covered with clay, to allow the rest of the mold to fill.
Gently pry the mold apart after allowing the silicone to set fully.
Separate the silicone from the original.
(bronze carving, carved bronze sculpture)
Gently pry the mold apart after allowing the silicone to set fully.
Separate the silicone from the original.
(bronze carving, carved bronze sculpture)